250mm Trading Card Box, a 3D Print
I made this top-load trading card box to store Magic: The Gathering cards I collected from centuries past. It will store around 800 cards and will fit cards having light sleeves. The lift-off lid has a 0.6mm width and length clearance gap from the main container, providing a comfortable fit. All walls are 1.2mm, giving it adequate strength with minimal material usage.
The depth is 250mm, so a printer with a larger bed is needed. I plan to create smaller models for smaller beds.



Estimated Resources
- Print Time: 16hrs, 51min (with 50mm/s print speed)
- Material Use: 139g, 46.48m
(sliced with Ultimaker Cura 5.1)
Recommmended Print Settings
- Resolution: 0.2mm
- Support: none
- Infill: 20%
- Raft/Brim: none
- Vertical Walls: 4
- Horizontal Walls: 3
Printed With
- Printer: Creality CR-10 v2
- Filament: Hatchbox PLA, 1.75mm (white)